Echelon Resistance Knob not Working? How to Fix it?

Cycling Inspire is Supported By Its Audience. As An Amazon Associate We Earn From Qualifying Purchases, at No Extra Cost To Our Readers! Learn More

Your echelon resistance knob not working? It is either the knob itself is broken, or the magnet that attaches the knob to the bike is dislodged.

Here we’ll show you how to fix a broken echelon resistance knob so you can get back to your workout routine as soon as possible!

What Causes a Bike Resistance Knob That’s Not Working?

There are a few things that could be causing your bike’s resistance knob to stop working.

The first thing you should check is the battery. If the battery is dead, it will need to be replaced.

If the battery is not the problem, the next thing to check is the connection between the resistance knob and the bike. Make sure that the connection is secure and that there are no loose wires.

If neither of those solutions works, the next step is to take a look at the resistance mechanism itself.

The most common issue here is that the flywheel has come loose.

To fix this, you’ll need to tighten the bolts that hold the flywheel in place. Once you’ve done that, try pedaling again to see if the resistance has been restored.

How to Fix a Broken Echelon Resistance Knob?

There are two main reasons why an echelon resistance knob might stop working: either the knob itself is broken, or the magnet that attaches the knob to the bike is dislodged.

If the problem is with the knob, the first thing you’ll want to do is remove it from the bike.

To do this, simply unscrew the knob until it comes off. Once it’s off, check to see if the plastic housing around the knob is cracked or damaged in any way. If it is, you’ll need to replace the entire knob.

However, if the housing looks fine, then all you need to do is reattach the knob by screwing it back on.

If the problem is with the magnet, the first thing you’ll want to do is locate it on the bike. The magnet should be located under the seat, near where the resistance knob attaches to the bike.

Once you’ve found it, simply reattach it to the bike by pressing it back into place. If the magnet won’t stay in place, you may need to use a bit of glue or tape to keep it in place.

Once you’ve fixed either issue, your echelon resistance knob should be working properly again!


If your echelon resistance knob has stopped working, don’t panic! In most cases, the issue is an easy fix that can be completed in just a few minutes.

Here, we showed you how to troubleshoot and fix both common issues that can cause a resistance knob to stop working. So get out there and get your workout on!